30,000 Mile Scheduled Maintenance

Subaru 30,000 Mile Service Schedule

Perform at 30,000 Miles, 90,000 Miles, etc

• Replace engine oil, filter and drain plug washer
• Inspect and adjust all drive belts to factory specifications
• Inspect and ensure cooling fan is operating within factory specifications
• Inspect transmission fluid
  
• Check to ensure air conditioning and heating systems are operating within factory specifications
• Rotate tires, inspect tread wear and check and adjust tire pressure as needed
• Perform brake system inspection; pads and/or drums, lines, hoses and fluid
• Inspect suspension system and steering components to ensure factory specifications
• Inspect battery and clean terminals, check battery condition
• Inspect wiper blades and linkage operation
• Lubricate all door, trunk and hood latches and hinges if needed
• Inspect exhaust system and heat shields
• Inspect front and rear differential fluid
• Inspect radiator and cooling system
• Adjust emergency brake to within factory specifications if needed
• Replace air filter element
• Inspect steering operation, tie rod ends and steering rack guides per factory specifications
• Inspect all engine and transmission mounts
• Inspect and adjust all fluid levels as needed
• Check all interior and exterior lighting operation
• Replace brake fluid
• Factory trained technician to conduct road test

• Replace Pollen Filter every 12,000 miles (if equipped)
• Replace engine coolant and test protection levels
• Replace fuel filter on 2004 and older vehicles only every 30,000 miles
• Replace non-platinum spark plugs 2004 and older every 30,000 miles
• Replace platinum spark plugs 2005 and newer on 4 cylinder engines every 30,000 miles